Code P2442 Hyundai: Check Engine Light

Hyundai: Check Engine Light And Code P2442

Follow this Real Fix to see how to diagnose a P2442 code on this 2007 Hyundai Santa Fe using a smoke machine to verify its EVAP system problem.

hyundai check engine light evap

Follow this Real Fix to see how to diagnose a P2442 code on this 2007 Hyundai Santa Fe using a smoke machine to verify its EVAP system problem.

Model: 2007 Hyundai Santa Fe GLS 2.7L

Complaint: The customer states the check engine light is on.

Cause: Connected a scan tool and found code P2422 – EVAP Emission System – Vent Valve Stuck Close.

Service Procedure:

1. Connected a smoke machine to the evaporative emission (EVAP) system, induced smoke into the system and found smoke leaked from the EVAP vent valve, indicating an open vent valve.

2. Used the scan tool to command the EVAP vent solenoid closed and observed smoke stopped flowing from the EVAP vent valve, indicating a functional EVAP vent valve.

3. Used the smoke machine to perform an EVAP system pressure check and observed the system was able to hold pressure.

4. Used the scan tool to monitor live data and found the EVAP fuel tank pressure sensor signal parameter was above the specified range of 1.4 to 1.6 volts, indicating a vacuum in the fuel tank.

5. Removed the gas cap and observed the EVAP fuel tank pressure sensor signal parameter did not return to the specified range of 1.4 to 1.6 volts.

6. Visually inspected the fuel tank pressure sensor wiring harness and found no obvious signs of damage.

7. Used the scan tool to monitor the fuel tank pressure sensor parameter and wiggled the fuel tank pressure sensor wiring harness. Note: The fuel tank pressure sensor parameter did not change as the harness was wiggled, which indicated no circuit faults were present.

hyundai check engine light fuel pressure regulator

8. Backprobed the fuel tank pressure sensor signal circuit and monitored the sensor signal on a labscope.

9. Used a vacuum pump to apply positive pressure to the fuel tank pressure sensor and observed that its signal did not respond to changes in applied pressure. These test results verified the fuel tank pressure sensor was faulty.

Correction: Replaced the fuel tank pressure sensor, cleared codes, performed a road test and verified the vehicle operated properly. The check engine light did not illuminate and no fault codes returned.

Courtesy of Mitchell 1 SureTrack Real Fix.

You May Also Like

Honda Indirect TPMS Systems

Honda indirect TPMS systems do not have air pressure sensors inside the tires.

Indirect Tire Pressure Monitoring Systems (TPMS) are systems that do not have air pressure sensors inside the tires. Rather, they detect a low tire by comparing relative wheel speeds via the Anti-lock Brake System (ABS) wheel speed sensors. When a tire loses air, its diameter decreases slightly.

Older indirect TPMS are not as sensitive to changes in tire pressure as direct systems that actually monitor the air pressure inside the tire, but they are not as expensive either. 

Honda Oil System Inspection

The leading cause of low oil pressure-related complaints with Honda vehicles is the oil level.

Lexus Air Ride Repair

A conversion kit might cost less and provide better long-term results for the customer.

Toyota Direct Injection? Port Injection? Why Not Both?

Port fuel injection and direct fuel injection systems each have their advantages and disadvantages.

Toyota Squeaking Noise From Rear Suspension 

Follow the repair procedure in this bulletin to address this condition.

Other Posts

Exhaust Gas Recirculation Operation and Diagnosis

Since exhaust gas does not burn, this lowers the combustion temperatures and reduces NOx emissions from the engine.

Timing BMW VANOS N53 And N54 

To service them, you will need the appropriate toolset to lock the crank and camshaft.

Don’t Miss The April Digital Edition of ShopOwner

The April issue includes technical and management content and is free to download.

VW/Audi PCV Service

The PCV valve regulates the flow of gases from the crankcase.