Tech Tip: Chrysler Van's Accessory Drive Belt Squeals

Tech Tip: Chrysler Van’s Accessory Drive Belt Squeals

If a customer's 2001 Caravan, Town & Country or Voyager has an accessory drive belt that squeals or jumps off the pulleys, check for water that may be leaking from the wiper module drain tube connector and dripping onto the accessory drive belt. In colder climates, ice can form on the accessory drive belt and may cause the belt to jump off the pulleys when the vehicle is started. Locate the wiper module drain tube near the top of the right strut tower. With the hood open, direct water into the ....

If a customer’s 2001 Caravan, Town & Country or Voyager has an accessory drive belt that squeals or jumps off the pulleys, check for water that may be leaking from the wiper module drain tube connector and dripping onto the accessory drive belt.

In colder climates, ice can form on the accessory drive belt and may cause the belt to jump off the pulleys when the vehicle is started.

Locate the wiper module drain tube near the top of the right strut tower. With the hood open, direct water into the cowl grille. If water leaks at the wiper module drain tube connector, perform the Repair Procedure.

Repair Procedure

  1. Remove the drain tube connector from the wiper module and clean the mating surface.
  2. Install the foam seal (P/N 05080824AA) onto the drain tube connector making sure it is fully seated into the recess of the connector. See Figure 1.
  3. Install the drain tube connector to the wiper module making sure it is seated correctly.
  4. If the accessory drive belt has jumped off the pulleys, inspect the belt for damage and replace if necessary. Follow the procedures in the 2001 RS service manual for accessory drive belt installation.

Courtesy of Identifix.

For more information, visit www.identifix.com.

You May Also Like

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Here is a diagnostic puzzle: An owner comes to your shop complaining that it takes longer than expected to start his car’s engine in the morning. There are no codes for the crankshaft and camshaft sensors. And, the oil pressure is within specifications. If you are lucky, you might have a code for low fuel pressure on the high side of the direct injection system. What could be the source of the problem?

Melted Connectors

Too Much Current…or Something Else?

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

Hyundai Genesis Dongle Causing Multiple Issues

Aftermarket dongles may interfere with the Control Area Network (CAN) system, causing issues.

Audi Remote Key Inoperative

Replacing the remote will not resolve the concern. 

Other Posts
Mercedes-Benz: Replacing Bolts at Steering Gear

Work procedures vary slightly for certain platforms. This article outlines the different procedures to follow.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Strut Sales

It all comes down to educating the customer about the benefits and asking for the sale.

Hyundai DDMS Customer Complaints

The following Advanced Driver Assistance Systems (ADAS) features may be affected.