Tech Tip: BMW Clean Oil Drain Plug

Tech Tip: BMW Clean Oil Drain Plug

You may encounter an oil drain plug on a late-model BMW (2018 and newer) that is just the cover for the drain.

You may encounter an oil drain plug on a late-model BMW (2018 and newer) that is just the cover for the drain. This drain plug is designed to work with BMW’s Clean Oil system. The system was a pilot program for BMW in 2024 and 2025 at select dealers. The program will roll out fully in 2026. 

The drain plug cover goes over a fitting that is placed in the oil pan. The system is designed to use a hose and fitting that connect to the fitting in the pan. Oil is held in the pan by applying negative pressure to the crankcase using a vacuum when the cover is removed. The system is designed to reduce the mess of an oil change and have less environmental impact. The fitting on the oil pan uses an o-ring that should be replaced every oil change.

BMW offers the plugs in the following sizes:

  • 12 m x 1.5
  • 18m x 1.5
  • 14 mm x 1.5 

NOTE: The S68T and N20 plastic oil pan Clean Oil Service drain plug application is still in development.

You May Also Like

Melted Connectors

Too Much Current…or Something Else?

If you diagnose electrical issues in the shop, chances are good that you have discovered melted electrical connectors [Figure 1]. This type of failure is something that I have seen more frequently in the past few years. These problems typically exist in higher amperage circuits such as headlamps, cooling fans, etc. In many cases the damage is to the point that the connector, or even the entire harness, must be replaced. Once we locate the circuit problem, the damage can be repaired. But what caused the failure in the first place? 

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

Hyundai Genesis Dongle Causing Multiple Issues

Aftermarket dongles may interfere with the Control Area Network (CAN) system, causing issues.

Audi Remote Key Inoperative

Replacing the remote will not resolve the concern. 

Mercedes-Benz: Replacing Bolts at Steering Gear

Work procedures vary slightly for certain platforms. This article outlines the different procedures to follow.

Other Posts
PennGrade Offers Gear Oil Fill Pouches

The pouch is designed to help reach tight and awkward fill locations where bottles can be difficult to maneuver.

Timing BMW VANOS N53 And N54 

To service them, you will need the appropriate toolset to lock the crank and camshaft.

BMW N54 Cooling System Problems

Let’s take a closer look at this unique water pump, how to replace it efficiently and what other components should be replaced along with it.

Read the September Digital Edition of ShopOwner Now

The latest issue includes technical, management and commentary content and is free to download.