Tech Tip: GM Intake Manifold Inspection and Replacement Pointers

Tech Tip: GM Intake Manifold Inspection and Replacement Pointers

When replacing an engine due to internal damage, extreme care should be taken when transferring the intake manifold to the new Goodwrench service engine long block. Internal damage may result in the potential discharge of internal engine component debris in the intake manifold via bent, broken or missing intake valves.

General Motors offers the following technical service bulletin that covers intake manifold inspection/replacement after severe internal engine damage.

When replacing an engine due to internal damage, extreme care should be taken when transferring the intake manifold to the new Goodwrench service engine long block. Internal damage may result in the potential discharge of internal engine component debris in the intake manifold via bent, broken or missing intake valves.

After removing the intake manifold from the engine, the technician should carefully inspect all of the cylinder head intake ports to see if the valve heads are still present and not bent. Usually when the valve heads are missing or sufficiently bent, internal engine component debris will be present to varying degrees in the intake port of the cylinder head.

If this debris is present in any of the cylinder head intake ports, the intake manifold should be replaced. This replacement is required due to the complex inlet runner and plenum configuration of most of the intake manifolds, making thorough and complete component cleaning difficult and nearly impossible to verify complete removal of debris. Re-installation of an intake manifold removed from an engine with deposits of internal engine component debris may result in the ingestion of any remaining debris into the new Goodwrench service engine. This may cause damage or potential failure to the new service engine.

Technical service bulletin courtesy of Mitchell 1.

For more information on Mitchell 1 products and services, automotive professionals can log onto the company’s website at www.mitchell1.com.

You May Also Like

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Here is a diagnostic puzzle: An owner comes to your shop complaining that it takes longer than expected to start his car’s engine in the morning. There are no codes for the crankshaft and camshaft sensors. And, the oil pressure is within specifications. If you are lucky, you might have a code for low fuel pressure on the high side of the direct injection system. What could be the source of the problem?

Melted Connectors

Too Much Current…or Something Else?

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

Hyundai Genesis Dongle Causing Multiple Issues

Aftermarket dongles may interfere with the Control Area Network (CAN) system, causing issues.

Audi Remote Key Inoperative

Replacing the remote will not resolve the concern. 

Other Posts
Mercedes-Benz: Replacing Bolts at Steering Gear

Work procedures vary slightly for certain platforms. This article outlines the different procedures to follow.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Strut Sales

It all comes down to educating the customer about the benefits and asking for the sale.

Hyundai DDMS Customer Complaints

The following Advanced Driver Assistance Systems (ADAS) features may be affected.