Tech Tip: Fuel Pump is the Rx for this Infiniti QX56

Tech Tip: Fuel Pump is the Rx for this Infiniti QX56

Recently, a customer encountered trouble climbing a grade in his 2005 Infiniti QX56 while towing his boat. He called to express his concerns about the Infiniti’s sudden lack of power. When accelerating with wide open throttle, the engine power is ....

By Eric Seifert
Automotive Technical Editor

Recently, a customer encountered trouble climbing a grade in his 2005 Infiniti QX56 while towing his boat. He called to express his concerns about the Infiniti’s sudden lack of power.

When accelerating with wide open throttle (WOT), the engine power is reduced.

Actions
1. Check fuel pressure during a transmission Stall Test (see Service Procedure).

2. If fuel pressure test is NG, replace the fuel pump.

Note: Low fuel pressure may cause DTCs to be detected. If you have DTCs with this incident, first replace the fuel pump and then recheck the DTC diagnosis.

Important: The purpose of these “Actions” is to give you a quick idea of the work you will be performing. You must closely follow the entire Service Procedure as it contains information that is essential to
successfully completing this repair.

Applicable Vehicles: 2004-’07 QX56 (JA60); 2004-’06 all VINs; and 2007-Built before 5N3M08(**)7N 806064 (Built before Feb. 22, 2007)

Parts Information: A new fuel pump, P/N 17040-7S20A (2004-’06) or 17040-ZE00B (2007), along with a fuel pump O-ring, 17342-7S000, may be required to complete the repair. See Figure 1.

Service Procedure
1. Connect a fuel pressure gauge to the engine (special tool kit J-44321 or equivalent).
• Follow all instructions under “Fuel Pressure” in ALLDATA for connecting the fuel pressure gauge.

2. Look at the fuel pressure while performing a transmission “Stall Test.”
• The Stall Test 10-minute warm-up is not needed for this Service Procedure.
• Follow all other instructions for performing the Stall Test under Automatic Transmission Testing in ALLDATA.

Caution: Do not hold down the accelerator pedal for more than five seconds while performing the Stall Test.

• Fuel pressure is NG if it drops below 45 psi during the Stall Test.
– If the fuel pressure is OK, this bulletin does not apply.
– If the fuel pressure is NG, go to step 3.

3. Replace the fuel pump.
• Follow all instructions under Fuel Pump in ALLDATA.
• Use the fuel pump listed in the Parts Information.
• Make sure to use a new fuel pump O-ring seal.

4. Test-drive the vehicle; make sure the incident is fixed.
Note:
• Low fuel pressure may cause DTCs to be detected. If you have DTCs with this incident; first replace the fuel pump and then recheck the DTC diagnosis.
• DTC diagnosis and repair is not covered by this procedure.

Written by ALLDATA Technical Editor, Eric Seifert, an ASE certified Master Technician and Engine Machinist, with 20 years of independent shop and parts store experience.

Courtesy of ALLDATA.

For additional information, visit www.alldata.com.

You May Also Like

Toyota Regenerative Braking System

The brake system of a hybrid may have multiple components to perform regenerative braking and pedal simulation.

With conventional friction brakes, the energy of forward motion (kinetic energy) is transformed into heat energy, via friction, and then dissipated into the air. A Toyota hybrid vehicle recharges its high voltage battery through the use of regenerative braking. 

With regenerative braking, instead of just wasting that energy by releasing it into the air, the vehicle takes it and places it in a box in the back of the car to save it as stored energy. Later, that stored energy will be converted back into kinetic energy and poured back into the operation of the car.

Regenerative Braking Service

Regenerative braking takes the forward motion of the vehicle and turns it into electrical energy.

Toyota Prius Battery Codes P0A7F, P2011 and P0A80

A second generation Toyota Prius is at least 12 years old and batteries may need to be replaced. Here’s what the codes mean.

Air Ride Diagnostics: Reservoirs and Compressors

The secret to diagnosing air ride problems is knowing what criteria the system uses to regulate the compressor/reservoir and having the right tool.

Mazda SkyActiv Engine Service Tips

These engines have been reliable, but there are four pattern failures you might see.

Other Posts

Don’t Miss The April Digital Edition of ShopOwner

The April issue includes technical and management content and is free to download.

Mercedes-Benz: Replacing Bolts at Steering Gear

Work procedures vary slightly for certain platforms. This article outlines the different procedures to follow.

Solving Intermittent Overheating

New cooling systems anticipate and influence changes in coolant temperature.

Now Available – March’s Digital Edition of ShopOwner

The March issue includes technical and management content and is free to download.