Toyota Tech Tip: Sulfur-Like Smell Coming from Exhaust

Toyota Tech Tip: Sulfur-Like Smell Coming from Exhaust

Some owners of Toyota vehicles may experience a sulfur-like or rotten egg odor coming from the exhaust system. Sulfur is a natural component of crude oil from which the gasoline is refined and the amount of sulfur can be decreased through the refining process. The amount of sulfur in fuel sold in California is regulated, however gasoline sold in other states can have substantially higher sulfur content. Sulfur content also varies considerably between gasoline brands and locations.

Some owners of Toyota vehicles may experience a sulfur-like or rotten egg odor coming from the exhaust system. Sulfur is a natural component of crude oil from which the gasoline is refined and the amount of sulfur can be decreased through the refining process.

The amount of sulfur in fuel sold in California is regulated, however gasoline sold in other states can have substantially higher sulfur content. Sulfur content also varies considerably between gasoline brands and locations.

Applicable Vehicles
• All models.

Repair Procedure
A sulfur odor emitted from the vehicle’s tailpipe does not necessarily indicate that there is an issue with the engine’s running condition, but is most likely directly related to the fuel. If the vehicle is exhibiting an excessive sulfur odor, the following checks should be performed.

• If the MIL light is ON, check for DTCs and repair as necessary.

If no trouble is found after performing the above check, recommend the customer try a different source of fuel.

Replacement of oxygen sensors, air/fuel ratio sensors or catalytic converters will not reduce the odor and will therefore not be considered warrantable.

Technical service bulletin courtesy of Mitchell 1.

For more information on Mitchell 1 products and services, automotive professionals can log onto the company’s website at www.mitchell1.com.

You May Also Like

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Ever since the fuel pump was moved to the fuel tank, fuel pressure replaced the float height as a measure of fuel system health and performance. Checking the height of the float might have required some disassembly or special tools to bend the arms of the float.

When the shift was made to port or throttle body fuel injection, all a technician needed to diagnose a fuel problem was a set of “noid lights,” a fuel pressure gauge and maybe a multi-meter. Measuring the fuel pressure typically required checking the pressure at idle and under load. Most of the these tools can’t be used on the high pressure side of a direct-injection system because of higher pressures and changes in the injector location and technology. 

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Electric Power Steering Diagnostics

Load management for steering systems.

Other Posts

Don’t Miss The April Digital Edition of ShopOwner

The April issue includes technical and management content and is free to download.

Now Available – March’s Digital Edition of ShopOwner

The March issue includes technical and management content and is free to download.

Now Available – February’s Digital Edition of ShopOwner

February’s issue includes technical and management content and is free to download.

How To Service BMW Tire Monitor Systems

BMW has offered Tire Pressure Monitoring Systems (TPMS) for more than 20 years. These early indirect and direct systems were implemented not to meet the 2007 government mandate but to inform the driver when an expensive Michelin or Bridgestone run-flat tire was deflating. Some 2002 and 2003 models have an indirect system called Flat Tire