Tech Tip: Quaker State Dispels Some Motor Oil Myths

Tech Tip: Quaker State Dispels Some Motor Oil Myths

Unfortunately, it seems as if myths about motor oil just never stop. But by informing the customer of the truth behind them from an educational perspective, not from a sales perspective, we chip away at the myths and your customers may look at you with even more confidence.

Let’s dispel some motor oil myths so that you can educate your customers the next time you hear one:

“Oil Brand A caused sludge in my father’s car 10 years ago.”
Assuming for a moment that the oil itself caused the problem then, please keep in mind that the oil industry moves forward quite often. For example, when the industry moved from GF-2 to GF-3 and also from GF-3 to GF-4, the oil formulations likely changed to keep up with the specifications. So assuming this story was once true, the oil formulations have changed substantially since that time.

“Don’t use Oil Brand A because it contains paraffins.”
Paraffins are basically wax, which can be good for lubrication when handled properly. Conventional motor oils and even some synthetic motor oils may include small amounts of paraffins — regardless of brand. But the refineries of today remove practically all of them and additives called “pour point depressants” are put into oils to control what’s left of the wax. Handled properly, you can still make quality lubricants with great low-temperature performance.

“Thicker oil is better because it provides higher oil pressure.”
It all depends. Thicker oil does typically provide higher oil pressure, but the manufacturers’ recommendations balance oil pressure versus oil flow. The manufacturer originally designs the clearances, oil pump and passages for the recommended oil viscosity and oil temperatures at those locations.

“Oil is oil. I found some at the store the other day for a fraction of the price.”
Be sure to read the oil’s label and make sure that it meets the requirements for your vehicle. Be aware that some non-detergent motor oils are available at certain stores that will not meet the manufacturers’ requirements, even for some of the older vehicles still on the road today.

Unfortunately, it seems like these and other myths just never stop. But by informing the customer of the truth behind them from an educational perspective, not from a sales perspective, we chip away at the myths and your customers may look at you with even more confidence.

Courtesy of Quaker State.

For additional information on products offered by Quaker State, visit www.Qpower.com.

You May Also Like

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Ever since the fuel pump was moved to the fuel tank, fuel pressure replaced the float height as a measure of fuel system health and performance. Checking the height of the float might have required some disassembly or special tools to bend the arms of the float.

When the shift was made to port or throttle body fuel injection, all a technician needed to diagnose a fuel problem was a set of “noid lights,” a fuel pressure gauge and maybe a multi-meter. Measuring the fuel pressure typically required checking the pressure at idle and under load. Most of the these tools can’t be used on the high pressure side of a direct-injection system because of higher pressures and changes in the injector location and technology. 

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Electric Power Steering Diagnostics

Load management for steering systems.

Other Posts

Solving VW False Fuel Pressure Reading

First, verify the customer did not run out of fuel at the time the DTCs were stored.

vw steering wheel squeak
Tech Tips for Dorman’s OE FIX Steering Tie Rod End Assembly

Read the tech note for tips on installation of this unique fix.

Acura Frozen Starter Causes No Start

Why won’t the engine crank after the vehicle has been exposed to precipitation and then freezing temperatures?

Beating the Tech Shortage Through Mentoring

How understanding the 80/20 Rule and creative mentoring can make the shortage less threatening.