Tech Tip: How Motor Oil Helps Keep Engines Running Clean

Tech Tip: How Motor Oil Helps Keep Engines Running Clean

As anyone who has even a small amount of experience working on engines knows, regular oil changes are one of the most important things that can be done to extend the life of an engine. Premium-quality motor oil will maintain its effectiveness over the life of the oil drain, allowing it to help keep the engine clean.

As anyone who has even a small amount of experience working on engines knows, regular oil changes are one of the most important things that can be done to extend the life of an engine. Premium-quality motor oil will maintain its effectiveness over the life of the oil drain, allowing it to help keep the engine clean.

Additive packages are added to motor oil and play a key role in helping to keep an engine clean and protected from varnish and sludge, as well as wear from heat and acids. Additives can consist of anti-wear agents, friction modifiers, dispersants, detergents, viscosity index improvers and antioxidants. Some key cleaning ingredients that make up motor oil additive packages are detailed below:

• Anti-wear additives lay down a protective, sacrificial film between moving parts and also help stop oxidation of the motor oil.

• Dispersants grab dirt and sludge before they can build up during engine operation, holding them in suspension and preventing them from depositing onto engine parts.

• Detergents help keep high-temperature surfaces such as pistons clean. Changing the motor oil at proper intervals will help to prevent ring sticking and piston deposits.

• Viscosity index improvers are chemical additives that are added to motor oil to ensure proper oil viscosity at extreme cold and hot operating conditions, enabling the development of multi-grade oils such as SAE 5W-20.

• Friction modifiers help to reduce friction in critical areas of the engine, thus enhancing the vehicle’s fuel economy.

• Anti-oxidants stop oil oxidation to help keep the oil from becoming too thick.

Properly functioning engine oils help enhance fuel economy, prevent sludge and varnish deposits, and maintain proper low-temperature pumpability. The additives in engine oils are consumed during use at different rates, which vary with vehicle, engine type and driving conditions; therefore, it’s not possible to establish a universal oil drain interval. Always follow the recommended oil drain interval and oil specifications found in the owner’s manual.

Courtesy of Pennzoil.

For additional information on products offered by Pennzoil, visit www.pennzoil.com.

You May Also Like

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Millimeters Matter

When you set up a target or fixture for a camera or radar, the position and distance from the vehicle are critical to the performance and operation of the system. If the target or fixture is a few millimeters off when placed a few meters from the sensor, it can change the alignment of the sensor by meters when it is pointed down the road or the vehicle’s height is in the blind spot

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Electric Power Steering Diagnostics

Load management for steering systems.

Solving VW False Fuel Pressure Reading

First, verify the customer did not run out of fuel at the time the DTCs were stored.

vw steering wheel squeak

Other Posts

Tech Tips for Dorman’s OE FIX Steering Tie Rod End Assembly

Read the tech note for tips on installation of this unique fix.

Acura Frozen Starter Causes No Start

Why won’t the engine crank after the vehicle has been exposed to precipitation and then freezing temperatures?

Beating the Tech Shortage Through Mentoring

How understanding the 80/20 Rule and creative mentoring can make the shortage less threatening.

Nissan Key Will Not Start

Nissan keys use radio frequencies (RF) similar to other everyday wireless devices.