Tech Tip: GF-5 Motor Oil Specifications

Tech Tip: GF-5 Motor Oil Specifications

As engine technology advances to produce more efficient engines, motor oil must continue to meet the increasing demands for lubricating these precision-made engines. Development of the next specification of gasoline-fuel (GF) motor oil began only months after the latest specification, GF-4, became available in 2004.

As engine technology advances to produce more efficient engines, motor oil must continue to meet the increasing demands for lubricating these precision-made engines. Development of the next specification of gasoline-fuel (GF) motor oil began only months after the latest specification, GF-4, became available in 2004.

The GF-5 motor oil specification created by the International Lubricant Standardization and Approval Committee (ILSAC) is scheduled to take effect in the summer of 2009 and will be the factory fill for 2010 model-year engines. GF-5 motor oils will be the most technologically advanced motor oil, exceeding the current GF-4 category in a number of important performance areas.

ILSAC identified several major areas that automakers would like to see improved with the GF-5 category. These areas include: fuel economy and fuel economy retention throughout the oil drain; emission-control systems protection; and increased sludge, deposit and oxidation control. In addition, ILSAC identified a number of other areas to be addressed by the GF-5 specification, including low-temperature viscosity, high- and low-temperature corrosion, turbocharger protection and filter clogging protection.

Aeration control, the reduction of tiny air bubbles, is a renewed concern because modern engines demand that oil serve as a hydraulic fluid in cam phaser devices, variable valve actuators, timing chain tensioners and hydraulic lash adjusters that allow for variable valve timing. These increased demands cause engine oils to be stressed more than ever before.

One of the highest priorities for automakers and engine oil manufacturers is making GF-5 motor oil backward compatible. Developing engine oil that is compatible for new and older engines helps prevent misapplications.

Provided by the makers of Pennzoil products.

For additional information on products offered by Pennzoil, visit www.pennzoil.com.

You May Also Like

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Ever since the fuel pump was moved to the fuel tank, fuel pressure replaced the float height as a measure of fuel system health and performance. Checking the height of the float might have required some disassembly or special tools to bend the arms of the float.

When the shift was made to port or throttle body fuel injection, all a technician needed to diagnose a fuel problem was a set of “noid lights,” a fuel pressure gauge and maybe a multi-meter. Measuring the fuel pressure typically required checking the pressure at idle and under load. Most of the these tools can’t be used on the high pressure side of a direct-injection system because of higher pressures and changes in the injector location and technology. 

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Electric Power Steering Diagnostics

Load management for steering systems.

Other Posts

Solving VW False Fuel Pressure Reading

First, verify the customer did not run out of fuel at the time the DTCs were stored.

vw steering wheel squeak
Tech Tips for Dorman’s OE FIX Steering Tie Rod End Assembly

Read the tech note for tips on installation of this unique fix.

Acura Frozen Starter Causes No Start

Why won’t the engine crank after the vehicle has been exposed to precipitation and then freezing temperatures?

Beating the Tech Shortage Through Mentoring

How understanding the 80/20 Rule and creative mentoring can make the shortage less threatening.