Vehicle Application:
2001 BMW 325ci 2.5L
2002 BMW 325xi Sport Wagon 2.5L, Eng Des M54
2003 BMW 325xi Sport Wagon 2.5L, Eng Des M54
2003 BMW 330i 3.0L
2004 BMW 325i Sport Wagon 2.5L
2004 BMW 325xi Sport Wagon 2.5L
2004 BMW x5 4.4L, Eng Cfg V8, Eng Des N62, USA/Canada
2005 BMW 325i 2.5L, Eng Des M54
2005 BMW 325xi 2.5L
2005 BMW 330i 3.0L
Tests/Procedures:
1. After replacing the pads and wear sensor, turn the ignition on and wait for at least 30 seconds, then start the engine. If the pad wear circuit is good, the light should go out with no further procedures.
2. If it does not go out, check for reference voltage from the cluster to the left front sensor, with the sensor disconnected. Check the other wire at the sensor for direct continuity to ground. If it is not a good ground, check the rear sensor for continuity to the front sensor on one wire, and continuity to ground on the other wire. Replace the rear sensor and/or repair the ground connection as necessary.
Courtesy of Identifix.
