Tech Tip: Curing Unstable Idle Conditions on Hyundai Vehicles

Tech Tip: Curing Unstable Idle Conditions on Hyundai Vehicles

Some Hyundai vehicles with 2.4L or 3.5L engines may experience an intermittent unstable idle condition. Follow this simple procedure to diagnose an intermittently sticking closed EGR solenoid valve.

Some Hyundai vehicles with 2.4L or 3.5L engines (see affected models below) may experience an intermittent unstable idle condition with the following symptoms:
• Intermittent unstable/rough idle condition;
• The check engine light may or may not be on. If it is on, code P0401 (EGR insufficient flow) may be stored; and
• The condition may not be present when the engine is cold. Once the engine warms up, the unstable idle condition may appear.

AFFECTED MODELS:
• 1999-2004 Sonata 2.4L;
• 2001-2004 XG300/XG350; and
• 2001-2004 Santa Fe 2.4/3.5L.

If a vehicle has the above-described condition, follow the simple procedure below to diagnose an intermittently sticking closed EGR solenoid valve. The EGR solenoid valve is a normally open-type valve. If the solenoid is not energized, the valve is open and allows the vacuum to bleed off (not opening the EGR valve). At idle, the EGR solenoid valve is not energized and, thus, the EGR valve is not open.

Note: For detailed information on EGR system function and diagnosis, refer to TSB #01-36-021.

DIAGNOSTIC PROCEDURE:
1. Duplicate the unstable/rough idle condition (warm up the engine).
2. While the engine is idling roughly, disconnect the green striped vacuum hose from the top of the throttle body.
3. If the idle becomes normal, the EGR solenoid valve is sticking closed.

For additional information, visit www.alldata.com.

Technical service bulletin courtesy of ALLDATA.

You May Also Like

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Ever since the fuel pump was moved to the fuel tank, fuel pressure replaced the float height as a measure of fuel system health and performance. Checking the height of the float might have required some disassembly or special tools to bend the arms of the float.

When the shift was made to port or throttle body fuel injection, all a technician needed to diagnose a fuel problem was a set of “noid lights,” a fuel pressure gauge and maybe a multi-meter. Measuring the fuel pressure typically required checking the pressure at idle and under load. Most of the these tools can’t be used on the high pressure side of a direct-injection system because of higher pressures and changes in the injector location and technology. 

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Electric Power Steering Diagnostics

Load management for steering systems.

Other Posts

Don’t Miss The April Digital Edition of ShopOwner

The April issue includes technical and management content and is free to download.

Now Available – March’s Digital Edition of ShopOwner

The March issue includes technical and management content and is free to download.

Now Available – February’s Digital Edition of ShopOwner

February’s issue includes technical and management content and is free to download.

How To Service BMW Tire Monitor Systems

BMW has offered Tire Pressure Monitoring Systems (TPMS) for more than 20 years. These early indirect and direct systems were implemented not to meet the 2007 government mandate but to inform the driver when an expensive Michelin or Bridgestone run-flat tire was deflating. Some 2002 and 2003 models have an indirect system called Flat Tire