GM Eight Speed Torque Converter Shudder Solution (VIDEO)

GM Eight Speed Torque Converter Shudder Solution (VIDEO)

The solution to this problem can be lengthy and complicated. This video is sponsored by LubeGard.

Welcome to the GM eight speed torque converter shudder solution by LubeGard. General Motors has issued multiple technical service bulletins on torque converter clutch shudder in the 8-speed, 8L45 and 8L90 transmissions. This problem affects over four million vehicles. That’s 11 different models across three different OE manufacturers between the model years 2015 and 2020. GM’s solution to this problem is lengthy and complicated. It requires a full fluid exchange that uses 20 quarts of an expensive and very specific full synthetic ATF.

Our research and development team went to work by replicating conditions that caused torque converter shudder using our state-of-the-art Falex MultiSpecimen Test Machine. We use this testing platform to create conditions that cause shudder to occur between an automatic transmission friction plate and a steel plate, replicating the movement in a torque converter. When the friction and steel plate specimens were lubricated with the GM recommended ATF alone, shudder and slippage still occurred.

We then ran the exact same test under the same conditions with the addition of Lube Gard Platinum ATF Protectant at a treat rate of two ounces per quart. The shudder was eliminated. The testing also shows that platinum provided control and stabilization of the fluid friction at a constant level throughout the test.

You can avoid the expensive replacement of the OEM ATF by simply adding two 10 ounce bottles or 20 ounces of Lube Gard Platinum ATF Protectant. If you do decide to go with the OEM fluid flush, you can add the platinum and prevent the torque converter shudder from returning. By adding platinum you’ll also be protecting the transmission from friction, wear, heat and additive depletion.

For more information on LubeGard products and where to purchase them, visit our website at www.lubegard.com, or send us an email at [email protected]. Thanks for watching.

This video is sponsored by LubeGard

You May Also Like

BEV Brake Service Tips

Andrew Markel shares his latest service tips in the all new BendPak EV Garage video series.

If you are servicing the brakes or suspension system on a Tesla Model S, you do not need fancy orange gloves or insulated tools. The brake system on the vehicle uses the 12-volt electrical system and not the 400-volt electrical system. Still, it is always a good practice to disconnect the 12-volt power system if you must remove a caliper or replace a brake hose.

Get to Know Performance Ride Technology

PRT is a global OE supplier with more than 5,000 products available in the United States.

PRT Heavy Duty Highlights Shocks for Commercial Vehicle Applications

Learn to install PRT Heavy Duty’s gas-charged shocks for enhanced driving stability in trucks and buses.

Why You Should Replace The Thermostat

It is always best practice to replace the thermostat on a vehicle after it has overheated. Sponsored by Auto Value and Bumper to Bumper.

The Importance of Volunteering in the Aftermarket with Jon Owens

Owens describes what he’s learned from volunteering in the industry and his vision for AACF as its current president.

Other Posts

Tensioner Tech Assist

The Lift and Pin is designed to simplify tensioner replacement and belt installation. This video is sponsored by Litens.

EV Cooling Systems

The large batteries that EVs carry need to be maintained within a specific temperature range for optimal performance.

What Constitutes A Complete Brake Job?

Complete, safe brake jobs are key. This video is part of the Group Training Academy.

Decoding Brake Pull Issues

Addressing brake pulls requires diagnostic dedication. This video is part of the Group Training Academy.