Tech Tip: Subaru Cylinder Head Installation

Tech Tip: Subaru Cylinder Head Installation

The AERA (Engine Rebuilders Association) Technical Committee offers the following information regarding cylinder head installation for 2002-'05 Subaru 2.0L DOHC EJ20DT engines. This information is somewhat unique and should be referenced any time a cylinder head is re-installed.

The AERA (Engine Rebuilders Association) Technical Committee offers the following information regarding cylinder head installation for 2002-’05 Subaru 2.0L DOHC EJ20DT engines. This information is somewhat unique and should be referenced any time a cylinder head is re-installed.

This engine requires pre-stressing the cylinder head gasket and then a relaxing procedure when installing the cylinder head. Failure to follow the following procedure (Figure 1, 2002-’05 Subaru 2.0L DOHC cylinder head installation procedure) may result in premature head gasket failure.

Apply a coat of clean engine oil to washers and bolt threads.
1. Torque all bolts to 22 ft.-lbs. (29 Nm) in alphabetical sequence.
2. Torque all bolts to 51 ft.-lbs. (69 Nm) in alphabetical sequence.
3. Loosen all bolts in reverse alphabetical sequence 180°.
4. Loosen all bolts, yet one more time in reverse alphabetical sequence 180°.
5. Torque all bolts 29 ft.-lbs. (39 Nm).
6. Tighten all bolts 80-90° of rotation in alphabetical sequence.
7. Tighten all bolts 40-45° of rotation in alphabetical sequence.
Caution: Do not tighten the bolts more than 40-45°.
8. Further tighten only bolts A and B 40-45° of rotation in alphabetical sequence.

Courtesy of AERA.

You May Also Like

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

Millimeters Matter

When you set up a target or fixture for a camera or radar, the position and distance from the vehicle are critical to the performance and operation of the system. If the target or fixture is a few millimeters off when placed a few meters from the sensor, it can change the alignment of the sensor by meters when it is pointed down the road or the vehicle’s height is in the blind spot

Air Ride Diagnostics: Reservoirs and Compressors

The secret to diagnosing air ride problems is knowing what criteria the system uses to regulate the compressor/reservoir and having the right tool.

Mazda SkyActiv Engine Service Tips

These engines have been reliable, but there are four pattern failures you might see.

Honda Indirect TPMS Systems

Honda indirect TPMS systems do not have air pressure sensors inside the tires.

Honda Oil System Inspection

The leading cause of low oil pressure-related complaints with Honda vehicles is the oil level.

Other Posts

Now Available – March’s Digital Edition of ShopOwner

The March issue includes technical and management content and is free to download.

ADAS Calibration Aborts

Knowing the common “hiccups” can save you time and money.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

Now Available – February’s Digital Edition of ShopOwner

February’s issue includes technical and management content and is free to download.