Tech Tip: Lift Safety Question From Autocarepro:news Reader

Tech Tip: Lift Safety Question From Autocarepro:news Reader

Question: I am having a consistent problem with cables breaking on one of our lifts. I have replaced seven cables since this lift was purchased in 1997. The lift manufacturer has been contacted and they claim that this is normal wear. Can you give me any help or advise?

QUESTION:
I am having a consistent problem with cables breaking on one of our lifts. I have replaced seven cables since this lift was purchased in 1997. The lift manufacturer has been contacted and they claim that this is normal wear. I have another brand lift purchased in 1989 and have not had any cables replaced and none even look worn. Can you give me any help or advise?

Thanks,
Bill Adler
Autocarepro:news reader

RESPONSE:
Different brands of lifts have different drive systems (cables, leaf chains or direct drive). All lifts have specific manufacturers’ maintenance instructions that should be complied with. Of the three different lifting drive systems, cable systems have the highest maintenance, and highest cost to maintain, while direct drive lifts have the lowest. However, the cables of your lift are specifically designed for that brand, capacity and model of lift. Hopefully, you are using OEM cables, as aftermarket parts should never be used on any manufacturers’ lift.

In general, lifts designed with cables typically have a one- or two-year service life before cable replacement is required. Your lift that has not had cables replaced since 1989 should have them replaced immediately, as worn cables are difficult to detect due to the fact that they may:

1. Wear from the inside, with no visible sign of wear;

2. It is suggested that a full-length, visual inspection be made to see that there are no single strands of cable protruding from anywhere along the main cable (a sure sign that it’s time to replace the cable); and

3. The instruction manual of the lift probably doesn’t imply that the cables life is good for 17 years. However, your newer lift(s) that require annual cable replacement may be "standard" for that specific brand of lift. Like anything in life; you get what you pay for.

Annual lift inspections by a trained lift inspector are an OSHA requirement for all garages, per ANSI ALIOIM. Besides the obvious issue of the safety of your employees and your customers vehicles, as a shop owner, not having the paperwork on file documenting the annual lift inspections can lead to OSHA fines upwards of thousands of dollars.

Good Luck,
Steve Perlstein
Mohawk Lifts
www.mohawklifts.com

You May Also Like

Solving VW False Fuel Pressure Reading

First, verify the customer did not run out of fuel at the time the DTCs were stored.

vw steering wheel squeak

MIL ON with DTCs P310B, P129F, P008B, P129E, P008A, P2540 or P0087 Stored in ECM Fault Memory

2007-2008 Eos (2.0L - BPY)

2007-2008 Jetta (2.0L - BPY)

2007-2008 GTI (2.0L - BPY)

Tech Tips for Dorman’s OE FIX Steering Tie Rod End Assembly

Read the tech note for tips on installation of this unique fix.

Acura Frozen Starter Causes No Start

Why won’t the engine crank after the vehicle has been exposed to precipitation and then freezing temperatures?

Strut Sales

It all comes down to educating the customer about the benefits and asking for the sale.

Beating the Tech Shortage Through Mentoring

How understanding the 80/20 Rule and creative mentoring can make the shortage less threatening.

Other Posts

Nissan Key Will Not Start

Nissan keys use radio frequencies (RF) similar to other everyday wireless devices.

Taking the Fear out of ASE Testing

Spring registration now open; Register by June 30.

Audi EVAP Case Study

Let’s look at some of the things that you should know about Audi EVAP systems before trying to tackle such a repair.

Exhaust Gas Recirculation Operation and Diagnosis

Since exhaust gas does not burn, this lowers the combustion temperatures and reduces NOx emissions from the engine.