Tech Tip: AGM Battery Testing and Replacement

Tech Tip: AGM Battery Testing and Replacement

AGM (Absorbed Glass Mat) batteries are in the most sophisticated and power hungry vehicles. These batteries are more deep cycle in nature and considered to be more durable within certain parameters. AGM recombinant batteries have a very low internal resistance reducing heat during high charge/discharge levels and very low static charge loss of about 1% to 3% per month.

by Rob Morrell
WORLDPAC Training Institute (WTI) Director of Technical Training

AGM (Absorbed Glass Mat) batteries are in the most sophisticated and power hungry vehicles. These batteries are more deep cycle in nature and considered to be more durable within certain parameters. AGM recombinant batteries have a very low internal resistance reducing heat during high charge/discharge levels and very low static charge loss of about 1% to 3% per month.

AGM batteries are used in vehicles with high potential load, therefore an AGM battery should only be replaced with another AGM Battery of equal capacity. A common mistake is replacing an AGM with a regular wet lead acid battery and may destroy the regular wet battery within a couple weeks because of the high demands on it.

Charging of the AGM battery also needs special attention; the charging voltage cannot exceed 14.8 volts even for short periods of time without damaging an AGM battery. AGM Batteries can withstand very high charging currents, but not voltage; a slow charge is always the best, most efficient practice. High heat from an engine compartment can also dramatically reduce the AGM battery life; these batteries were never designed for higher temperatures.

To test a high capacity AGM battery, you must begin with a fully charged battery (see ‘Battery Conditions’ below). You can usually remove the surface charge by turning the key on for about three minutes. Conductance battery testers can usually work well if they have the right information, but appear to be more accurate with wet type batteries than AGM models; AGM batteries sometimes give false positive results. A load test is the best testing method to avoid unnecessary comebacks.

AGM batteries should be load tested for 15 seconds at:
• 1/2 the CCA rating (Cold Cranking Amps); and
• 3 times the Ah rating (Amp hour rating).
NOTE: The voltage must not drop below 9.7 volts for the duration of the test.

Battery Conditions
12.65 V = 100% charge
12.45 V = 75% charge
12.24 V = 50% charge
12.06 V = 25% charge
11.89 V = 0% charge

Tech Tip courtesy of WORLDPAC Training Institute (WTI).

For additional information on WORLDPAC Training Institute (WTI) and products offered by WORLDPAC, visit www.worldpac.com.

You May Also Like

Solving VW False Fuel Pressure Reading

First, verify the customer did not run out of fuel at the time the DTCs were stored.

vw steering wheel squeak

MIL ON with DTCs P310B, P129F, P008B, P129E, P008A, P2540 or P0087 Stored in ECM Fault Memory

2007-2008 Eos (2.0L - BPY)

2007-2008 Jetta (2.0L - BPY)

2007-2008 GTI (2.0L - BPY)

Tech Tips for Dorman’s OE FIX Steering Tie Rod End Assembly

Read the tech note for tips on installation of this unique fix.

Acura Frozen Starter Causes No Start

Why won’t the engine crank after the vehicle has been exposed to precipitation and then freezing temperatures?

Strut Sales

It all comes down to educating the customer about the benefits and asking for the sale.

Beating the Tech Shortage Through Mentoring

How understanding the 80/20 Rule and creative mentoring can make the shortage less threatening.

Other Posts

Nissan Key Will Not Start

Nissan keys use radio frequencies (RF) similar to other everyday wireless devices.

Taking the Fear out of ASE Testing

Spring registration now open; Register by June 30.

Audi EVAP Case Study

Let’s look at some of the things that you should know about Audi EVAP systems before trying to tackle such a repair.

Exhaust Gas Recirculation Operation and Diagnosis

Since exhaust gas does not burn, this lowers the combustion temperatures and reduces NOx emissions from the engine.