Tech IQ: Getting Rid of Code P0315 (VIDEO)

Tech IQ: Getting Rid of Code P0315 (VIDEO)

The code might set again when the engine is cranked. This video is sponsored by Auto Value and Bumper to Bumper.

If you replaced the ECM or crankshaft position sensor, a new code for the crankshaft position sensor called P0315 might be set. You might be able to clear the code with a scan tool, but it might set again when the engine is cranked.

In this video, we cover what it takes to keep code P0315 away by programming or calibrating the crankshaft position sensor.

This video is sponsored by Auto Value and Bumper to Bumper.

You May Also Like

Replacing Chassis Parts in Pairs (VIDEO)

You are not doing the customer any favors by installing just one strut, spring, or bushing. This video is sponsored by TRW.

You are not doing the customer any favors by installing just one strut, spring, or bushing.

While the bill might be half the price, they could be paying more than the full price down the road.

This car had a broken right rear spring. The owner replaced only the spring and strut in that corner. This made the handling erratic and the headlight patterns were not aligned with the road.

Auto Pros on the Road: Ode’s Auto Repair In Warren, MI

Ode Auto Repair and Tire is a NAPA Gold Certified Auto Care Center focused on customer satisfaction since 1979.

New TPMS Technologies for Tesla Vehicles (VIDEO)

TPMS technology has evolved along with other vehicle systems. This video is sponsored by Walker Products.

Engine Oil Protectant For Turbocharged Engines: LSPI

LSPI typically occurs at low speed and high low driving conditions. This video is sponsored by Lubegard.

Applying CVT Recharge (VIDEO)

CVT Recharge is a concentrated additive, formulated to provide anti-wear and extreme pressure protection. Sponsored by Lubegard.

Other Posts

Transmission Service

The following is an example of a dishonest vehicle and how to go about catching it in its lie.

Replacing A Window Regulator (VIDEO)

When replacing a window regulator or motor, look at the procedures in the service information. Sponsored by Lemförder.

CAT III Multimeters (VIDEO)

CAT III simply refers to the Category Safety Rating of the multimeter.

Understanding Ball Joints (VIDEO)

Always check manufacturer specifications and specific inspection procedures to be sure you are getting the job done right.