Mazda: Whining Noise From Automatic Transaxle

Mazda Tech Tip: Whining Noise From Automatic Transaxle

Some customers may complain of a whining noise from the automatic transaxle when driving at 10 mph and above. The noise depends on the vehicle's speed (the more speed, the more noise). The noise also occurs with all types of driving (acceleration, deceleration and steady speed).

Figure 1

TSB NUMBER: 05-002/19

Models:

2012-2013 Mazda3 (SKYACTIV A/T)
2014-2018 Mazda3 (SKYACTIV A/T)
2013-2016 CX-5 (SKYACTIV A/T)
2017-2019 CX-5 (SKYACTIV A/T except for 2.5T engine) with VINs lower than JM3KF515940 (produced before November 1, 2018) 2014-2017 Mazda6 (SKYACTIV A/T) 2018 Mazda6 (SKYACTIV A/T except for 2.5T engine) with VINs lower than JM1GL330038 (produced before November 1, 2018) 2016-2019 CX-3 (SKYACTIV A/T) with VINS lower than JM1DK427352 (produced before October 31, 2018)

Concern:

Some customers may complain of a whining noise from the automatic transaxle when driving at 10 mph and above. The noise depends on the vehicle’s speed (the more speed, the more noise). The noise also occurs with all types of driving (acceleration, deceleration and steady speed).

The whine does not depend on rpm, gear or ATF temperature.

Cause:

The whining noise is caused by a damaged bearing in the transaxle due to improper configuration of the transaxle case. A modification has now been implemented on automatic transaxles with the following serial numbers:
• 7TN0820364 and higher (CX-3) / 8TN1090104 and higher (except CX-3)
• 8TR1008883 and higher
• 8TD1003276 and higher
• 8T50331192 and higher (CX-3) / 8T50329705 and higher (except CX-3).

NOTE: The serial number can be found on top of the transaxle case near the manual shaft lever (see Figure 1).

Repair Procedure:

  1. Verify customer concern.
  2. Replace the 6AT assembly with a new one according to MGSS online instructions.
  3. Verify repair and align the vehicle.

You May Also Like

Toyota Squeaking Noise From Rear Suspension 

Follow the repair procedure in this bulletin to address this condition.

Some 2014 – 2019 model year Highlander and Highlander Hybrid vehicles may exhibit a squeak noise from the rear suspension (Figure 1). This condition may be more noticeable in colder ambient temperatures and may occur when traveling over uneven roads or when the vehicle comes to a complete stop. Follow the repair procedure in this bulletin to address this condition.

Toyota Milliwave Calibration Tips

Calibration is necessary due to several factors affecting the radar’s functionality.

Different Nameplates, Different Expectations

Honda is one of the least concerned manufacturers about system voltages when it comes to reflashing.

Nissan Electro Hydraulic Steering

Nissan’s steering system is susceptible to driver-error.

Subaru HVAC Diagnostics

On some more modern Subaru vehicles, you might be better off grabbing your scan tool.

Other Posts

Now Available – February’s Digital Edition of ShopOwner

February’s issue includes technical and management content and is free to download.

How To Service BMW Tire Monitor Systems

BMW has offered Tire Pressure Monitoring Systems (TPMS) for more than 20 years. These early indirect and direct systems were implemented not to meet the 2007 government mandate but to inform the driver when an expensive Michelin or Bridgestone run-flat tire was deflating. Some 2002 and 2003 models have an indirect system called Flat Tire

Tech Tip: Checking Transmission Fluid Levels When Cold or Hot

Checking the fluid level before the transmission has reached the specified temperature might cause a false reading

Now Available – January’s Digital Edition of ShopOwner

January’s issue includes technical and management content and is free to download.