Installing Subaru Stretch Belts
The stretch belt can help to simplify the serpentine belt system on the Boxer engine.
Nissan Frontier: Finding Failures, Faults
Nissan uses two accelerator pedal position (APP) sensors to transmit a throttle position command.
Alignment Specs: Scion FR-S And Subaru BR-Z
The alignment of these vehicles is straightforward, and a lot of adjustment is built into the vehicle.
Nissan Titan Rear Axle Service
The 2004-2015 Titan was Nissan’s first attempt at a full-sized truck for the North American market. It could be ordered as a fleet truck or as a fully optioned 4×4.
Solving 2014 Toyota Tacoma Cooling System Sensor Codes
The test monitor reads all relevant serial data parameters passing through the ECM.
Honda LIN Line Controlled Charging Systems
On most 2008 and newer Honda models, there is a battery sensor attached to the negative battery terminal.
Acura Tech Tip: Clunk From The Rear Suspension When Hitting Bumps
Inspect the rear dampers for any leaks or damage to make sure the dampers themselves are not the cause of the noise. Replace the damping rubber from both rear dampers with the updated damping rubber in the repair kit.
Kia Tech Tip: AWD System Hydraulic Actuator Replacement
This bulletin provides the procedure for replacement of the hydraulic actuator of some All-Wheel Drive (AWD)-equipped 2011-2016 Sportage trucks (produced from May 6, 2010-February 19, 2013) and some AWD-equipped 2011-2015 Sorento models (produced from October 24, 2009-December 11, 2014).
Honda Tech Tip: Low Tire Pressure And TPMS Indicator On After Recent Tire Replacement
The Honda CR-V uses an indirect TPMS system that uses the rolling circumference of the tire to determine the pressure in the tire. Differences in sidewall construction and weight of a replacement tire can cause the rolling circumference to change if a single tire is replaced.
Curing Honda Misfire Codes
While Honda engines have a great reputation for reliability, as the miles accumulate and maintenance is neglected, codes P0300-P0304 can be set for misfires. But a misfire code just indicates that the crank angle sensor didn’t detect the correct change in the speed of the crankshaft. If the engine still has compression, the most likely cause of the misfire could be a fuel injector or ignition coil.
Toyota Makes $391M Investment In Its San Antonio Assembly Plant
The total investment in Toyota Texas will exceed $3 billion, as the company commits to further fund local workforce development.
Mazda Tech Tip: Air Conditioning Musty / Mildew Odor
A musty odor may come from the vents when the A/C system is operating. It is most noticeable when the A/C is first turned on.
