Tech Tip: Audi 2.8L V6 Rear Crankshaft Seal Leaks After Replacement

Tech Tip: Audi 2.8L V6 Rear Crankshaft Seal Leaks After Replacement

Oil may leak from the rear crankshaft seal after seal replacement due to the seal lip rolling while installing the new seal. This condition affects 1996 A4 with 2.8L V6 (Engine Code AFC). When replacing the seal, the new seal is supplied pre-installed in the flange.

This condition affects 1996 A4 with 2.8L V6 (Engine Code AFC). When replacing the seal, the new seal is supplied pre-installed in the flange. 



Seal/Flange P/N: 078 103 171H 



Flange gasket P/N: 078 103 181 (must be ordered separately).



Caution: Part numbers are for reference only.



1. Carefully remove installation tool that comes with seal and apply a small amount of engine oil to the inner lip of the seal.



Note: Lubricating the seal lip will ease seal installation and reduce the tendency of the seal to roll as it is being installed.



2. Carefully reinstall the seal installation tool.



3. Install oil seal and flange with new gasket.



4. Torque reusable flange bolts to 7 ft.lbs. (10Nm).

Some or all of this information was provided by the Automotive Parts Remanufacturers Association (APRA). For more information on technical bulletins available through APRA call 703-968-2772 or visit www.AutoBulletins.com.

You May Also Like

Today’s Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Ever since the fuel pump was moved to the fuel tank, fuel pressure replaced the float height as a measure of fuel system health and performance. Checking the height of the float might have required some disassembly or special tools to bend the arms of the float.

When the shift was made to port or throttle body fuel injection, all a technician needed to diagnose a fuel problem was a set of “noid lights,” a fuel pressure gauge and maybe a multi-meter. Measuring the fuel pressure typically required checking the pressure at idle and under load. Most of the these tools can’t be used on the high pressure side of a direct-injection system because of higher pressures and changes in the injector location and technology. 

BMW Diagnostics: Low Airflow After Cabin Filter Replacement

Models:  F97 X3 M  F98 X4 M G01 X3 G02 X4 G20 3-Series SITUATION After replacing the microfilter during a previous service, the customer notices that the ventilation system airflow rate is noticeably less. This leads to perceived lower cooling power. The customer may also notice that external odors enter the vehicle. Related Articles –

Volvo Modular Engine Service

The Volvo Modular Series engine outlasted Ford and was retired by Geely. The Volvo modular design that can have four, five or six cylinders made its debut in 1990 in the 960 sedan as a six-cylinder and never stopped improving. Related Articles – Audi Active Suspension Service – How To Service BMW Tire Monitor Systems

BMW Dual Clutch Transmissions

BMW uses a wet clutch with separate inboard and outboard sections for the two sub-transmission.

BMW Cooling System Problems

Let’s take a closer look at this unique water pump, how to replace it efficiently and what other components should be replaced along with it.

Other Posts

Now Available – March’s Digital Edition of ShopOwner

The March issue includes technical and management content and is free to download.

ADAS Calibration Tips

Here are 10 tips to follow during ADAS Calibration.

ASE Education Foundation, Goodguys Continue Partnership

Goodguys is one of many industry relationships the foundation has developed to help solve the technician shortage.

Valvoline Celebrates Female Service Center Employees

As women make up more than half of all drivers in the United States, Valvoline is taking steps to increase their vehicle care confidence.