Oil Level Sensors - More Than A Warning Light

Oil Level Sensors – More Than A Warning Light

Oil level sensors have been used on import and domestic cars for more than a decade. Some of the first applications only monitored if the oil level was low using a switch attached to a float. The sensor would just trigger a message or light in the instrument cluster and only measured oil levels when the engine was not running.

Oil level sensors have been used on import and domestic cars for more than a decade. Some of the first applications only monitored if the oil level was low using a switch attached to a float. The sensor would just trigger a message or light in the instrument cluster and only measured oil levels when the engine was not running.

Modern oil level sensors measure the oil level differently so the oil level can be measured with the engine running. Some sensors use an electrical resistance method that works the same way as a mass airflow sensor. As less of the sensor is covered by oil, the resistive value of the sensor changes. Newer ultrasonic sensors have a piezoelectric transducer which sends ultrasonic pulses into the oil and receives echoes from the oil surface inside the sensor’s body.

This information is sent to the ECU and data like engine speed, temperature and even vehicle attitude from the ABS system is used to determine the dynamic oil level.

The ECU can then alert the driver to add more oil if the level is low.

On some applications, the ECU can put the engine into a restricted power mode or not allow the engine to start if the oil level is too low.

You May Also Like

AC Service – R1234yf

With a few simple steps, you can ensure that your A/C machine is properly maintained and ready for the upcoming A/C season!

Summer is just around the corner, and this is a perfect time to get your air conditioning machine serviced before the busy A/C season hits your garage bays. As the summer winds down and we move into the cooler months, most A/C machine usage winds down as well, with the machine sitting idle for longer periods of time, often unserviced at the end of the season. Now is the perfect time to get it ready to prevent any unwanted “downtime” from a machine that wasn’t serviced. Let’s look into what you can do to get your equipment ready.

Ignition Coil Output

To see inductance inside the primary windings, use an amp probe placed around the positive wire for the ignition coil.

Compressor Oil for R1234yf

Working on R-1234yf systems is not that different from the R-134a variety.

Turbochargers on Minis

No matter if it is a BMW or MINI, when the engine stops turning, the oil flowing to the turbocharger stops.

How Extended Interval Oil Filters Have Been Improved

Over time, the oil filter can collect enough contaminants to become restricted. Here’s why new filters are better.

Other Posts

Honda Oil System Inspection

The leading cause of low oil pressure-related complaints with Honda vehicles is the oil level.

European Oil Specifications

If a manufacturer introduces a new vehicle with a new ACEA sequence specification, the oil must be on shelves.

AC Condensers

The characteristics that make the parallel-flow condenser so efficient are among its major drawbacks as well.

Lifter Deactivation

The area of contact between the lifters and cam lobes is the highest loaded surface inside an engine.